1 of 3 jobs- (pulling posts)  Slide Drivers-5 barrel onto and over old tee post at least 4 post-notches or 6 inches down, set pin in or across; then step out of post range when lifting. Second job-putting in old used t-posts with mushroomed tops slide up into barrel until you hit the latch – back out and slide inor across puller pin and press into ground.  3- For hard ground find an old t-post (Tougher has more cast-iron) Cut off top two lobes. Now shorten post to approx. 3 1/2 ft. and sharpen the bottom and first notch. Use puller pin to hold in barrel now press down lift up replace with new post drive now go back in same hole. One could add water before driving back down. If you didn't purchace the puller you could add a length of pipe so the tee post can't bend.The idea is to never/never doink your helper.Set your routine up with safety in mind for pinch, crunch points. Sole responsibility lies with you so please work safely. Any Questions please call- 1-580-747-9288   (Copyrighted all rights reserved)   ©